Cars & vehicles, Boats, watercraft with in Canada, Nova Scotia, Annapolis Valley.
-
1
Nice paddle 59 inches long. No cracks, in good shape. Just needs a coat of paint the color you want and it will be like new again.
-
2
New , never used in box.
-
3
Nice little 1956ish twin cylinder johnson , very little use by the looks of it ,
Call or text Jason @9028441976
-
4
Older scallop boat for sale (60ft)
Scallop license and quota available for rentContact me for more information
-
5
I am looking for a cracked, worn through, or otherwise damaged plastic kayak to buy cheap and fix. (Not quite as bad as the blue kayak in the photo.) The orange kayak had been dragged around to the point of being worn through by a previous owner. I did some successful "plastic welding" to it, and have paddled it over deep water with confidence.
A sit on kayak would be of the most interest.
Located in NW Kings County
-
6
1998 Yamaha Outboard 30 HP
Model: 30MSHW series
2-stroke; 2 cylinder; manual start & tilt; 132lbs; 15” short shaft; Tiller Handle
Would like to trade for 4-stroke 6-9.9HP outboard
-
7
16' Aluminum Princecraft Starfish 20 boat with Shorelander trailer and 25HP Honda engine.
Engine Details;
2001, 4 stroke engine
Engine runs great, lots of power for this boat. It gets it right up on plane and will stay there with the throttle reduced a bit.
I think the previous owners lost the original cowling. The cowling shown is from a 2006 engine and has obvious damage. The engine is not damaged.
Cowling seal and latch were replaced recently. Carbs overhauled and water pump replaced 3 years ago by Sampsons in Kingston.
See link for engine run-up: https://youtu.be/tqmq4T2E20sTrailer Details;
2005 Shorelander trailer
Safety is good until end of Aug 2023
On the last safety the trailer received new tires, a new 2" ball hitch and new wiring.Hull Details;
16' Aluminum Starfish 20
See link for tour:
https://youtu.be/YCS1lH348nMMinn Kota Maxxum Trolling motor with foot steer system. Bow reinforced with aluminum plate for trolling motor.
Two deep cycle marine batteries (2 years old)
Transom support for towing
Spare seat included
Pedestal seat on custom casting deck
Deck was re-done last year with coated 3/4" plywood. Created storage area for gear and trolling motor battery.
Transom shows some corrosion but is rock solid under power.
Large aluminum weld repair under both back seats. Work done by Nova Millwrights. Underside of hull has been extensively gone through and all small leaks have been patched with marine grade JB weld. Boat had no leaks last year.
Small bilge pump installed in the aft of the boat. I would leave the boat tied up at the dock all summer and this makes getting rain water out much quicker and easier.
Hull shows dents and scrapes but shouldn't leak and is in overall good shape.
Unsure of year of manufacture of the hull. I am guessing at 1995
-
8
1982 Mastercraft Competition Ski Boat
All original
302 V8 Pleasurecraft
This is a rare find!!
PM for more details.
Serious buyers only.
$14k obo
-
9
12 foot springbok aluminum with a 8hp two stroke Evinrude short shaft outboard ,on a great trailer. Deck built with treated lumber , Small storage built into the fishing deck , no leaks ,motor works FANTASTIC . This is the perfect small lake boat I’m absolutely In love with it but I have my eyes on a new project and need this one gone . $3700 obo located in wolfville . Will consider trades See less
-
10
1989 force 125hp
Parts or repair
Bought this as a parts motor but ended up being the wrong year ...
Box of new parts to with
Previous owner was in the process of rebuilding it and had lots of new parts
-
11
We have for sale a vintage outboard fuel tank "fuel caddy". The tank is metal and in good shape can certainly be used. This is a 5 Imperial gallon or 6 US gallon tank. Similar tanks are selling for over $100 online. Asking $50, located at Digby Deals, 15 Carleton street in Digby, N.S (corner of Carleton and First) 902-245-4466, sorry no holds without EMT. We buy quality items and gold. Open daily 10-5 closed Sunday's and Wednesday's.
-
12
Flo Tool multi purpose funnel. Fits all sizes of filler tubes. For trans fluid,power steering fluid and gas/oil additives. $5.00 cash.
-
13
ENGINE-2013 Mercuiser SeaCore, 220HP 4.3EFI, closed cooling system, dry exhaust, SmartCraft Digital Gauge Package showing 80hrs
OUTDRIVE-2013 Mercrusiser SeaCore, BRAVO 1 80hrs
BOAT- 1987 WellCraft V20 Steplift. Tansom and floor are in great shape, Paint "awlgrip" and wiring were professionally redone in 2013, new helm and steering cable last season , heavy duty RULE bilge pump.
New Garmin Echomap 75sv sonar/chartplotter with side imaging and down scan on a Ram mount, also has a humminbird 5" sonar/chart plotter combo.
TRAILER- 2013 tandem axle 6600lb full roller trailer with electric brakes. ALL New bearings, lights, brakes, and MVI.
-
14
I am looking for a cracked, worn through, or otherwise damaged plastic kayak to buy cheap and fix. (Not quite as bad as the blue kayak in the photo.) The orange kayak had been dragged around to the point of being worn through by a previous owner. I did some successful "plastic welding" to it, and have paddled it over deep water with confidence.
A sit on kayak would be of the most interest.
Located in NW Kings County
-
15
PHONE CALLS ONLY. Decomishioned boat. No engine or drive. Fiberglass. In very good condition. Fiberglass deck. Rear ladder. Would make a excellent house boat, warf, dock, party boat, etc. Was going to convert into a house boat, but bought a tractor, so guess its farming instead of fishing. Phone calls only. Evenings 902-584-3553.
-
16
27’ boat has a 350 290 HP inboard with a Volvo duo prop out drive top end of motor done last year has a radar chart plotter and fish finder all in working order boat is sitting on a trailer which would need some work if it is hauled any distance boat works well has small cuddy with a pump out toilet 35000 OBO no trades buying a bigger boat
-
17
Kayak saddles with straps.fits 1”/ 1.25” Thule bars.excellent condition.call 902-680-5418
-
18
25kw generator end for sale. Approximately 500 hours use. New price is $3000.00, asking $1500.00.
-
19
1997 Seadoo Challenger Jet Boat
• Great Winter Project
• Planned to fix up and use but unable to finish and have to sell do to no time or space. Some new repairs to seats were done. Mainly just needs seats recovered, wiring and some minor cosmetics to be ready for use.
• Currently has a non-original 15hp motor (single engine) that ran before restoration started. The factory original engine was a 787 2 cyl. Rotax
• No Papers
• No Trailer
• Will fit in 6 x 10ft utility trailer to transport (see pics)
• Controls, cables, steering, hull and body are in great shape with no previous damage.
-
20
Pelican Sport Pelican Boats - PS0145-2 - Universal Drain Plug, Black, One Size
New - $5
902-824-3300
-
21
1997 Seadoo Challenger Jet Boat
• Great Winter Project
• Planned to fix up and use but unable to finish and have to sell do to no time or space. Some new repairs to seats were done. Mainly just needs seats recovered, wiring and some minor cosmetics to be ready for use.
• Currently has a non-original 15hp motor (single engine) that ran before restoration started. The factory original engine was a 787 2 cyl. Rotax
• No Papers
• No Trailer
• Will fit in 6 x 10ft utility trailer to transport (see pics)
• Controls, cables, steering, hull and body are in great shape with no previous damage.
-
22
I have for sale a brand new Mercury Racing Twin Engine Zero Effort Left Hand DTS Throttle and Shifter with a trim switch on the throttle. The part number is 840714A 9 and comes in it's original box complete the wiring harness and the instructions in a sealed bag plus an open bag of parts. This throttle listed for over $1,600 but I am asking $800 US plus the postage for it. I have them listed on Scream & Fly in the US, so the item is advertised in US funds but I will convert them into CDN $$ at the time of the sale. Please let me know if you have any questions.
Thanks for looking
Gary
-
23
Kayak saddles with straps.fits 1”/ 1.25” Thule bars.excellent condition.call 902-680-5418
-
24
I am offering a like new Gaffrig twin engine horizontal trim indicator set-up. The head has a white face and bezel with the cables entering from the port side. It will come with two Morse 33C cables-18 ft and 21 ft, that are in great condition as well. I am selling these and replacing them with the Deluxe Stainless Marine trim and jack indicators, so I will be keeping my actuators to use with the new set-up. I am asking $250 US plus postage for it. I have this listed on Scream & Fly in the US, so they advertised in US funds but I will convert them into CDN $$ at the time of the sale. Let me know if you have any questions.
Thanks for looking
Gary
-
25
I have brand new 215 cm fiberglass shaft, made by Harmony kayak paddles. These paddles are left over from a business I closed. These retail around
$ 150.00 with HST but I am selling this these ones for $ 75.00, cash only.
call or text : Michael 902-844-1799
1323 Hwy 1, Kingston
-
26
I have brand new 225 cm and 235 cm fiberglass shaft, kayak paddles made by Harmony. These paddles are left over from a business I closed. These retail around $ 150.00 with HST and I am selling them for $ 90.00, cash only.
call or text : Michael 902-844-1799
1323 Hwy 1, Kingston
-
27
Since 1986 Bear River Plastics has been involved in floating projects other than docks and marinas. Check out some of things we have done in the past 34 yrs. 902-638-3438 -- www.plasticweld.ns.ca
-
28
I have 2 sets of brand new Feelfree Scupper for sale. They are $ 10.00 per set,
call or text : Michael at 902-844-1799
-
29
Kawasaki 650 cc
Twin motor
Bare motor no electronics
Stand up x2 550 swap etc
Call or txt 1-902-670-0870
-
30
Is the stitching getting weak on your canvas boat cover? We can re-stitch it with our heavy duty sewing machine. By trade we are a leather business (LuPe Leather), we are expanding in to this area.
Our studio is in Berwick, in the Annapolis Valley.
Please contact us for pricing.
-
31
Hemlock boat cradle with galvanize fasteners suitable for 20 to 30 foot boat excellent shape delivery can be arranged $400 calls only please 902-679-8771
-
32
If you think you have a unique dock problem, check out the pictures above. This is the Weymouth NS dock; 35' alum ramp and a 48'x10' dock that goes through 27' of tide twice a day and has NO mooring blocks attached. Let us come and do a FREE site visit to make sure the dock you get works exactly the way it should. Call Dave Wilson 902-638-3438 or check out our web-site www.plasticweld.ns.ca
-
33
2003 sea doo xp di 951cc